Filter
Top Products
EPL Commands
O
132
14245L-003 Rev. A EPL Programming Guide 12/16/13
O
Hardware Options
Description Use this command to select various printer options. Options available vary by
printer configuration.
Options selected and enabled in a printer can be verified by checking the printer configuration
printer status label. See the U command on page 148 and the Explanation of the Status
Printout on page 36.
Mobile printers, such as the TR 220, ignore this command.
Syntax O[C[p1],D,P,L,S,F]
Parameters This table identifies the parameters for this format:
Parameters Details
C = Enable optional
Label Liner Cutter
The cutter will cut at the end of each form as specified by the
Q command.
Cp
1
= Batch print labels
and liner cut
Sets the number of labels to print prior to cut.
If a number between 1 - 255 is specified for p
1
, the printer
will cut after the specified number of labels have been
printed.
If b is specified for p
1
, the “batch print & cut” feature is
enabled. This feature uses the P command to control cutter
operation.
D = Enable direct
Thermal Mode
Enable Direct Thermal Mode, use this option when using
direct thermal media in a thermal transfer printer.
d = Status
Not a command, this is a status only. Out of box default Direct
Thermal Mode setting used in a 2844, 2824 or 3842 thermal
transfer printer's and is displayed in the Dump Mode status
printout. Changing the printer to thermal transfer mode or
when the printer detects a transfer ribbon will cause this
option parameter to permanently be removed from the status
printout.
P = Enable label taken
sensor
Enable label taken sensor for the Label Dispense (Peel)
Mode.
L = Enable printer’s Feed
button
Enable the printer's Feed button for Tap to Print operation in
the Label Dispense (Peel) Mode. The printer will present each
label and wait for a tap of the Feed button before printing the
next label. Use this mode when printing multiple copies of
liner-free labels.