Filter
Top Products
279
SGD Wireless Commands
wlan.ip.gateway
12/16/13 EPL Programming Guide 14245L-003 Rev. A
wlan.ip.gateway
Description This command instructs the printer to change the wireless print server’s
gateway address. For printer support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • This setting refers to the gateway address. A set value is ignored if the IP protocol is
not set to permanent.
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the wireless printer
server’s gateway address.
Format:
! U1 getvar "wlan.ip.gateway"
setvar
This command instructs the printer to change the wireless printer server’s
gateway address.
Format: ! U1 setvar "wlan.ip.gateway" "value"
Va lues: Any valid gateway address
Default: "0.0.0.0"
Example • This setvar example shows the value set to "10.3.5.1".
! U1 setvar "wlan.ip.gateway" "10.3.5.1"
When the setvar value is set to "10.3.5.1", the getvar result is "10.3.5.1".