Filter
Top Products
EPL Commands
UI
154
14245L-003 Rev. A EPL Programming Guide 12/16/13
UI
Host Prompts/Codepage Inquiry
Description This command will cause the printer to enable prompts to be sent to the host
and it will send the currently selected codepage to the host through the RS-232 port.
This command also disables software flow control (XON/XOFF). Hardware flow control is
not disabled (DTR/CTS). To restart software flow control a reset (^@ command) or power
must be recycled.
See also the I and U commands.
Syntax UIp
1
,p
2
,p
3
Parameters This table identifies the parameters for this format:
Parameters Details
The printer will send information about the currently selected code page back to the host in
the following format:
p
1
Number of data bits.
p
2
Code page.
p
3
Country code.
Note • The KDU automatically sends this command each time power is applied.
Example •
UI↵