Filter
Top Products
Document No: LT0122 F3200 Installation & Programming Manual
Programming
Issue 2.7 5 July 2001 Page 6-23
GLOBAL DATA (CONTINUED)
For V2.07 and later software
1:Auto test; 2:FIP MCP; 3:FFCIF options; 4:All zones isolated; 5:More
3:FFCIF options provides the following:
FFCIF zones (MAF only, all, none)
Auto Ack enable/disable
FFCIF type 2/3
Remote Ack enable/disable
FFCIF alarm = bells on enable/disable
Display cause by default enable/disable
Always flash non-MAF alarm LEDs – enable/disable
Always send non-MAF FF alarm to RDU – enable/disable
5:more selects the following menu
1:Brigade test relay activate; 2:Printer setup;
3:Country coder; 4:more
4:More selects the following menu
1:Daylight saving start; 3:Mains/battery
2:Daylight saving end; 4:More
3:Mains/battery provides the following
Mains frequency 50/60Hz
Mains fail action
Battery low monitor enable
Battery tests enable
Charger fault monitor
4:More selects the following menu
1:Keys enable; 2:Remote sounder silence
3:Buzzer mode; 4:New Zealand mode options
The above items are described in more detail in the following pages.
Auto Test
The automatic test of memory, AZCs, etc, occurs at a programmed time every day except on
weekends or programmed inhibit dates. This is to reduce the cost of callouts should the
auto-test discover a "fault". Only the basic statutory holidays, 25/12, 26/12, 01/01, 02/01 &
weekends are inhibited by default. Other state/company specific ones should be added.
Note that the default programming does not include an alarm test of each AZC (zone) and to
disable the Auto Test completely set the Auto Test start time to 24:00:00.
FIP MCP
The default mapping for the FIP MCP is to zone 1, but any configured zone may be selected.
Note that in "special" FIPs which do not have an MCP fitted it should be disabled to prevent
Fault occurring on the zone it is mapped to. To disable it, select zone 0.
WARNING
It is possible to map the FIP MCP to a zone which is not configured.
This would not be displayed or logged and the MCP is disabled.