Filter
Top Products
F3200 Installation & Programming Manual Document No: LT0122
Appendix B
Page B-4 5 July 2001 Issue 2.7
F3200/NDU SYSTEM CONFIGURATION PAGE 2
REF:...............
AUTO TEST
Alarm test enable/disable Y/N:
Start time:
Inhibit dates:
SYSTEM OPTIONS
FIP MCP Zone 0 – 64
All zones isolated = standby Y/N
Activate relay for Brigade Test Y/N
FFCIF zones: MAF only/all/none
FFCIF type 2/3
FFCIF auto ack enable/disable Y/N
FFCIF allow remote ack from RDU Y/N
FFCIF display cause by default Y/N
FFCIF alarm → Bells on Y/N
FFCIF flash non maf alarm LEDs Y/N
FFCIF send non maf alarm to RDU Y/N
Country coder 0 – 6
Fault action text ……………………………………………………………
PSU/BATTERY OPTIONS
Mains enabled Y/N Mains Frequency 50/60
8 hours mains fail = fault Y/N Battery connection test enable Y/N
Charger high/low = fault Y/N Hourly Battery test enable Y/N
Battery low = fault Y/N Daily Battery test enable Y/N
BUZZER OPTIONS
Zone alarm buzzer enable Y/N Remote sys fault reset silences Y/N
Zone fault buzzer enable Y/N Remote FFCIF action silences Y/N
System fault buzzer enable Y/N Remote any command silences Y/N
Non-maf zone faults buzzer Y/N Receive network sounder silence Y/N
Faults resound after 8 hours Y/N Send any key net sounder
silence
Y/N
Sounder after 8 hours isolate Y/N Allow net sounder silence cmd Y/N
NEW ZEALAND MODE OPTIONS
New Zealand mode enabled Y/N Evac defect is fault Y/N
Battery very low is alarm Y/N External defect is fault Y/N
NZ Display Extender bd present Y/N