Filter
Top Products
Meter to Flow Computer Communication Worksheet 322
Reference, Installation, and Operations Manual Meter setup and configuration worksheet
3-9000-743 Rev S June 2013
E.2 Meter to Flow Computer Communication Worksheet
Fill in the worksheet, Tabl e E- 2, to use as a quick reference in setting up the Daniel 3400 Series Gas Ultrasonic Flow Meter
communications (refer to the Daniel MeterLink context sensitive Help (
F1) files at any time for details)
Type Description or P/N Manual Reference User Notes
• Calibration • Using Meter Factors for cali-
brating the meter.
• Factory calibration coefficients
for each flow direction
• Customer flow calibration
method
•
Section 5.7.2 and Section 5.7.3
• Table 5-22
• Table 5-23 to Table 5-25
• Maintenance Logs and Reports • Monitor a Liquid Ultrasonic
Meter for a user-defined set of
time and display the data and
results in a series of logs and
charts.
•
Section 5.9
Table E-2 Meter to Flow Computer Communication Worksheet (Sheet 1 of 9)
Description
The meter has three serial communication ports (Port A, Port B, and Port C) and one Ethernet port. Ports A and B can be configured for RS 232, RS 485 Full Duplex, and RS 485 Half
Duplex communication. Port C can be configured for RS 232 and RS 485 Half Duplex. A PC running Daniel MeterLink can be connected to the meter via RS 232, RS 485 Full Duplex
or Ethernet (i.e., not via RS 485 Half Duplex). A flow computer or RTU can be connected to the meter via any serial port (i.e., not the Ethernet port).
Serial Port A User Selection (Circle one)
Results (Enter here)
Connection to • <Flow computer,
RTU, etc.>
• PC running Daniel
MeterLink
• Not used
Table E-1 Daniel 3400 Series Gas Ultrasonic Flow Meter setup and configuration reference sheet (Sheet 6 of 6)