Filter
Top Products
Meter setup and configuration worksheet 320
Reference, Installation, and Operations Manual Meter setup and configuration worksheet
3-9000-743 Rev S June 2013
Type Description or P/N Manual Reference User Notes
• Port C
Series 100 Option Board or
Series 100 Plus Option Board
• RS-232
RS-485 *
Half Duplex
•
Table 3-20, Table 3-31, “Port C
Driver Configuration” on
page 78, Section 5.3.3
• Table 3-32,
• Frequency and Digital Output
Switch Settings
• Group 1 - frequency and digital
outputs (FO1A, FO1B, DO1A,
and DO1B)
• Group 2 - frequency and digital
outputs (FO2A, FO2B, DO2A,
and DO2B)
•
Section 3.5.2, Figure 3-25,
Figure 3-26, and Figure 3-27
• Analog (current) input for tem-
perature and pressure 4-20 mA
signals via Option Board or
HART® Option Board
• Switch settings configurable for
sinking or sourcing current via
Option Board switches
• Option Board:
Section 3.5.3
Series 100 Plus Option Board
Analog Output switch settings,
Page 3-86
Table 3-33 through Table 3-36
• Series 100 Option Board analog
output switch settings, Page 3-83,
Table 3-37 through Table 3-46
• Appendix Appendix I Daniel
drawing
DE-21056
*RS-485 Half Duplex can be used for Modbus Communications with a flow computer but cannot be used for communication with a PC running Daniel MeterLink.
• Configuration Protection
setting
• Protect configuration parame-
ters and firmware against
changes via CPU Board switch
S2 position 4
•
Section 3.5.8
• Section 5.6
Table E-1 Daniel 3400 Series Gas Ultrasonic Flow Meter setup and configuration reference sheet (Sheet 4 of 6)