Filter
Top Products
Reference, Installation, and Operations Manual Section 5: Startup and meter configuration
3-9000-743 Rev S June 2013
HART® Output Page 145
1. From the HART Output Page, choose the desired settings (Refer to Daniel P/N 3-9000-
754 HART® Field Device Specification Guide: Daniel Gas Ultrasonic Meter manual for a
detailed discussion on configuring the HART® outputs.) The manual is available on the
Daniel website:
http://www2.emersonprocess.com/en-US/brands/daniel/Flow/ultrasonics/Pages/Ultrasonic.aspx
Process variables are the four dynamic HART variables which you can configure for the
Daniel Ultrasonic Gas meter. The Primary variable is set to match the Content set for
Current Output 2. If you want a different Primary variable, you will need to go back to
the
Current Output Page and choose a different selection for its Content control for
Current Output 2.
a. Process Variable:
— Primary variable
— 2nd variable
— 3rd variable
— 4th variable
b. Options: Uncorrected (Actual) flow rate, Corrected flow rate, Average flow
velocity, or Average sound velocity, Energy rate, Mass rate, Pressure rate, or
Temperature rate
— Identification: Tag -
— Date -
— Message -
— Descriptor -
— Final assembly number -
— Polling address -
c. HART® units:
— Volume units -
— Flow rate time units -
— Velocity units -
— Pressure units -
— Temperature units -
2. Click the
Next button to continue the meter configuration. Daniel MeterLink displays
the
Field Setup Wizard - Meter Digital Outputs Page.