Filter
Top Products
Reference, Installation, and Operations Manual Section 5: Startup and meter configuration
3-9000-743 Rev S June 2013
Meter configuration setup wizard 119
5.6 Meter configuration setup wizard
Configuration protection must be disabled when configuring a Mark III meter, such as via
the Daniel MeterLink
Field Setup Wizard. See Section 3.5.8 and Section 5.6 for further
information on configuration protection.
If you are configuring the Mark III flow meter through the use of Modbus communica-
tions, see guidelines in this section about configuration, but also see Section 5.8.
If you are upgrading a Mark II meter to a Mark III meter, refer to Appendix C for
instructions on converting a Mark II configuration file for use in a Mark III.