Meter setup and configuration worksheet Reference, Installation, and Operations Manual
June 2013 3-9000-743 Rev S
321 Meter setup and configuration worksheet
Daniel MeterLink Software Startup and Meter Configuration
Type Description or P/N Manual Reference User Notes
• Communications Wizard • Establish communication
parameters for the Liquid Ultra-
sonic Meter. This includes both
the serial and Ethernet ports.
•
Table 5.1
• Section 5.1 through Section 5.6
• Field Setup Wizard
- Meter Configuration
- Communications Parameters
- Startup
- General
- Frequency Outputs
- Current Outputs
- HART® Outputs
- Meter Digital Outputs
- Meter Corrections
- Temperature and Pressure
- GC Setup
- AGA 8 Setup
- Continuous Flow Analysis
• Available while connected to a
meter used to enter site
specific information during
initial startup or to change:
- Meter units system
- Volumetric flow rate time
- Gage or Absolute Pressure
type
•
Table 5-1
• Table 5-11
• Section 5.3
• Update Time • The Update Time Wizard is
used to adjust the behavior of
the meter's signal sampling and
output updates.
•
Table 5-1
• Section 5.7.1
• Baseline Setup • Used to establish a baseline of
the meter’s flow characteris-
tics after installation. The
baseline can then used by the
Continuous Flow Analysis
features to monitor the health
of the meter.
•
Table 5-1
Table E-1 Daniel 3400 Series Gas Ultrasonic Flow Meter setup and configuration reference sheet (Sheet 5 of 6)