Filter
Top Products
166 Set calibration parameters
Section 5: Startup and meter configuration Reference, Installation, and Operations Manual
June 2013 3-9000-743 Rev S
Forward A3 Data points affected:
• FwdA3
Options:
• Enter a value (s
2
/m
2
or s
2
/ft
2
) within the range [-0.1,0.1 s
2
/m
2
].
Guidelines:
• This value should only be modified under direction of Daniel personnel.
• For additional guidelines, see Section 6.1.8 and Daniel MeterLink online help.
Reverse A0 Data points affected:
• RevA0
Options:
• Enter a value (m/s or ft/s) within the range [-1,1 m/s].
Guidelines:
• This value should only be modified under direction of Daniel personnel.
• For additional guidelines, see Section 6.1.8 and Daniel MeterLink online help.
Reverse A1 Data points affected:
• RevA1
Options:
• Enter a value (dimensionless) within the range [0.95,1.05].
Guidelines:
• This value should only be modified under direction of Daniel personnel.
• For additional guidelines, see Section 6.1.8 and Daniel MeterLink online help.
Reverse A2 Data points affected:
• RevA2
Options:
• Enter a value (s/m or s/ft) within the range [-0.1,0.1 s/m].
Guidelines:
• This value should only be modified under direction of Daniel personnel.
• For additional guidelines, see Section 6.1.8 and Daniel MeterLink online help.
Reverse A3 Data points affected:
• RevA3
Options:
• Enter a value (s
2
/m
2
or s
2
/ft
2
) within the range [-0.1,0.1 s
2
/m
2
].
Guidelines:
• This value should only be modified under direction of Daniel personnel.
• For additional guidelines, see Section 6.1.8 and Daniel MeterLink online help.
Table 5-22 Data Points for Dry Calibration
Daniel MeterLink
Display Name
Data Points, Options and Guidelines