Filter
Top Products
Reference, Installation, and Operations Manual Section 5: Startup and meter configuration
3-9000-743 Rev S June 2013
Configuration checksum value and date 123
To determine whether a particular data point is write- protected, consult Daniel MeterLink
online help. (There is a help topic for each data point, and each topic indicates whether the data
point is one that is protected when configuration protection is enabled. From Daniel MeterLink,
click on Help, click on Mark III
Registers Reference, select the Index tab, start typing the data
point name until the desired point is highlighted, and then click the Display button.)
Figure 5-6 Write protected registers
5.6.3 Configuration checksum value and date
The Mark III meter maintains a configuration checksum value
(CnfgChksumValue) and associated date (CnfgChksumDate). These values can be used to
determine if and when the meter configuration has last changed. In general, the data points
included in the configuration checksum consist of the write-protected configuration points and
the communication-related configuration points.
To determine whether a particular data point is included in the configuration checksum, consult
Daniel MeterLink online help. (There is a help topic for each data point, and each topic indicates
whether the data point is one that is included in the configuration. From Daniel MeterLink, click
on Help, click on Mark III
Registers Reference, select the Index tab, start typing the data point
name until the desired point is highlighted, and then click the
Display button.)
5.6.4 Meter configuration using Daniel MeterLink
The Daniel MeterLink Field Setup Wizard takes you through several pages to configure the
ultrasonic flow meter. Selections on the first page may limit which pages you go through.
Following is a list of pages in the Field Setup Wizard and the order in which they appear.
To view or edit a configuration in table format, use the Daniel MeterLink
Tools>Edit/Compare
Configurations
menu path:
• Startup Page Section 5.6.5
• General Page Section 5.6.6
• Frequency Outputs Page (Series 100 Option Board) Section 5.6.7
• Current Outputs Page Section 5.6.8
• HART® Output Page (Series 100 Plus Option Board) Section 5.6.9
• Meter Digital Outputs Page Section 5.6.10
• Meter Corrections Page Section 5.6.11