Filter
Top Products
136 Startup page
Section 5: Startup and meter configuration Reference, Installation, and Operations Manual
June 2013 3-9000-743 Rev S
To enable / identify the source of temperature / pressure for meter corrections,
configure these data points listed in the table below (requires the Option Board):
5. Click the checkbox(s) to enable or disable the desired Meter Outputs:
• Frequency outputs
• Current outputs
• HART® outputs (if the Series 100 Plus Option Board is installed)
• Digital outputs
6. Click the checkbox(s) to enable or disable:
• View Gas Chromatograph Setup
• View Continuous Flow Analysis
7. Click the
Next button to continue the meter configuration. Daniel MeterLink displays
the
Field Setup - General Page.
Pressure expansion
correction
Data points affected:
• EnableExpCorrPress
Options:
• Disable (FALSE)
• Enable (TRUE)
Guidelines:
• For options and guidelines, see Daniel MeterLink online help.
Table 5-13 Enable Temperature/Pressure Meter Corrections Data Points, Source
Daniel MeterLink
Display Name
Data Points, Options and Guidelines
Temperature for meter corrections Data points affected:
- EnableTemperatureInput
Options:
• Not used (0)
• Live (1) (only available with the Option Board)
• Fixed (2)
Guidelines:
• For options and guidelines, see Daniel MeterLink online help.
Pressure for meter
corrections
Data points affected:
- EnablePressureInput
Options:
• Not used (0)
• Live (1) (only available with the Option Board)
• Fixed (2)
Guidelines:
• For options and guidelines, see Daniel MeterLink online help.
Table 5-12 Enabling Meter Corrections
Daniel MeterLink
Display Name
Data Points, Options and Guidelines