Filter
Top Products
144 HART® Output Page
Section 5: Startup and meter configuration Reference, Installation, and Operations Manual
June 2013 3-9000-743 Rev S
5.6.9 HART® Output Page
The HART® Output Page allows you to configure the HART® output of the Daniel Ultrasonic
meter. This page is only displayed if the HART® Output was selected on the
Startup Page. If the
meter does not support the HART® protocol on its analog output, the HART® Output selection
on the Startup Page will be disabled and this dialog will not be displayed as you go through the
Field Setup Wizard.
If the Series 100 Plus Option Board is installed and you selected the HART® Output on the
Startup Page, Daniel MeterLink displays the
Field Setup Wizard - HART Output Page.
Figure 5-12 Field Setup Wizard - HART Output Page (Series 100 Plus Option Board)