Filter
Top Products
98 Communications
Section 5: Startup and meter configuration Reference, Installation, and Operations Manual
June 2013 3-9000-743 Rev S
Daniel MeterLink provides setup “Wizards” to simplify meter communications and
configurations (see Table 5-1).
Table 5-1 Daniel MeterLink setup wizards
Daniel MeterLink Setup Wizards
Wizard Description
Communications Meter Menu:
For establishing communication parameters for the Daniel Ultrasonic Gas Flow Meter. This includes
both the serial and Ethernet ports. Only ports and parameters available in the meter will be enabled
and configurable. The base meter contains two serial ports and one Ethernet Port.
See Section 5.2
through Section 5.5
Field Setup Meter Menu:
The Field Setup Wizard allows you to enter site specific information into the meter and is only
available while connected to a meter. It is designed to be used once during initial startup of the
meter to enter information unique to the meter’s installation. It can be used at a later time to
change the meter configuration. The Field Setup Wizard is the only way in Daniel MeterLink to
change the following parameters:
• Meter units system
• Volumetric flow rate time
• Gage or Absolute Pressure type
Depending on the version of firmware running on the meter, some options may be disabled or
unavailable in the Field Setup Wizard if the firmware can not support the option.