Filter
Top Products
KLVHS001–KLVSC009 67
KLVPM011 TERMINAL luname LOGGED OFF - ERPCOUNT EXCEEDED
Explanation: A terminal, "luname", has caused more simultaneous error
recovery operations than the ERPCOUNT limit set by the PSM command.
"luname" is logged off.
System Action: None.
User Response: None.
Message Type: INFO.
KLVPM012 PSM PRIVATE EXTENSION NOT INITIALIZED
Explanation: The PSM command was issued and the PSM private extension
was not available.
System Action: The PSM command is not executed.
User Response: Wait until CT/Engine has completed initialization, then reissue
the command.
Message Type: INFO.
KLVPM013 PSM ERP INFO BLOCK POINTER IS ZERO
Explanation: The PSM command was issued and the PSM ERP block was not
available.
System Action: The PSM command is not executed.
User Response: Wait until CT/Engine has completed initialization, then reissue
the command.
Message Type: INFO.
KLVPM021 INPUT PROCESSING EXCEPTION: RC=rc,lu_name,
modname,attention_code,fdbk, error_data,datastream
Explanation: An input message from the physical terminal has caused an
exception condition in PSM where
The following table lists possible reason codes for the input exception with
associated system action codes and user response codes. After locating the reason
code, refer to the appropriate system action and user response following this
table.
rc Identifies the reason for the error. See the reason code analysis
table below for more information.
lu_name Physical terminal LU name.
modname Module identifier.
attention_code Pending AID.
fdbk Feedback information internal to CT/Engine.
error_data Two bytes of error data. See the reason code analysis table below
for a description of the valid data.
datastream Up to first ten bytes of the input message causing the exception.