Filter
Top Products
110 Candle Products Messages Manual (KLVHS–KONCT)
KLVTB036 RECOVERY FAILED: TABLE(table)
Explanation: While processing a tables request, the CT/Engine tables manager
detected an error in the tables database for table. If there was an older copy of the
table on the database, the tables manager attempted to recover it, but that copy
also had errors. These errors were severe enough that no usable information
could be recovered. Previous KLVTB0nn messages should be present that
describe the original error.
System Action: The request is terminated with a nonzero return code. The
invalid table remains on the database.
User Response: Retain the CT/Engine run sheets, dump files, this message, the
MVS system log, and a copy of your tables database, then contact Candle
Customer Support. You must recreate the table and save it to the database after
the diagnostic information is obtained.
Message Type: LOG.
KLVTB037 WRITE ERROR: TABLE(table) RPLFDBWD(feedback) SEQUENCE(nnn)
RECORD(hex)
Explanation: The CT/Engine tables manager received a VSAM error while
updating the tables database for table. feedback is the RPL feedback word from
the failing request. nnn is the record sequence number for the table that was being
written. hex is the VSAM record contents.
System Action: The request is terminated with a nonzero return code. The
table remains open.
User Response: Refer to IBM’s Macro Instructions for Data Sets manual for the
meaning of the values in feedback. If the problem is not apparent, retain the
CT/Engine run sheets, dump files, this message, the MVS system log, and a copy
of your tables database, then contact Candle Customer Support.
Message Type: LOG.
KLVTB038 SYNC ERROR: TABLE(table) EXPECTED(edata) ACTUAL(adata)
SEQUENCE(nnn) RECORD(hex)
Explanation: While processing a tables request, the CT/Engine tables manager
detected invalid synchronization information in the tables database for table. A
VSAM record has been read that is not part of the table being loaded. edata is the
expected sync value; adata is the actual data read. nnn is the record sequence
number for the table that contains the block. hex is the block that was in error,
followed by the remainder of the VSAM record.
System Action: The tables manager will attempt to load a previous copy of the
table, if one exists (message KLVTB035), or will use the partially loaded table
(message KLVTB034).
User Response: None.
Message Type: LOG.