Filter
Top Products
KMQxx001E–KOCJ0046 341
KN3CV043 ETE INTERFACE DISABLED
Explanation: The ETE response time monitor component is currently disabled.
This is the initial default when the product is installed. The ETE feature must be
specifically enabled after first verifying that system incompatibilities do not exist.
System Action: All ETE response time monitor functions are disabled.
User Response: Refer to the OMEGAMON II for VTAM instructions shipped
with the product, the OMEGAMON II for VTAM CCUST., and the End-to-End
Response Time Feature Reference Manual for information about installing and
activating the ETE response time component.
Message Type: Installation error.
KN3CV044 THE OPERAND FOR THE AUTOREFRESH COMMAND MUST BE “ON”,
“OFF”, OR A NUMERIC VALUE FROM 10-3600 SECONDS
Explanation: The AUTOREFRESH command was entered on the command
line without specifying a valid operand.
System Action: None.
User Response: Enter the AUTOREFRESH command in one of the following
formats:
AUTO ON
AUTO OFF
AUTO nnnn
where nnnn is 10 to 3600 seconds.
Message Type: User input error.
KN3CV045 MUST BE IN THE RANGE OF 15—360 MINUTES
Explanation: An invalid value was specified for the recording interval on the
Global Options panel.
System Action: None.
User Response: Specify a number within the valid range (15—360 minutes).
Message Type: User input error.
KN3CV046 THE SAS SOURCE LIBRARY SPECIFIED CANNOT BE LOCATED. THE
DATASET MAY HAVE BEEN DELETED, RENAMED OR UNCATALOGED.
Explanation: The SAS source library name specified on the historical graph
options panel cannot be located.
System Action: None.
User Response: Verify the SAS macro library name specified is valid.
Message Type: User input error.