Filter
Top Products
KLVHS001–KLVSC009 39
KLVOP044 SESSION luname NOT FOUND
Explanation: The CT/Engine LOGOFF command was issued, but the session
between an active CT/Engine application and the LU luname could not be found.
System Action: The command fails.
User Response: Validate the name of the logical unit in question and reissue
the command.
Message Type: ERROR.
KLVOP046 SESSION TERMINATED: LU(lu)
Explanation: The session between an active CT/Engine application and logical
unit lu has been terminated by the LOGOFF command.
System Action: None.
User Response: None.
Message Type: REPLY.
KLVOP052 UNABLE TO LOAD APPLICATION EXIT: APPLID(applid) EXIT(exit)
Explanation: The OPEN command was issued, but CT/Engine could not load
the application module(s) associated with applid. This message is accompanied
by message KLVCM003, which gives a more specific reason why the module
could not be loaded.
System Action: The application is not opened.
User Response: Be sure that any module referenced on the open command is
located in the CT/Engine load library.
Message Type: ERROR.
KLVOP053 APPLICATION STARTED: APPLID(applid)
Explanation: The application applid was started successfully by the OPEN
command.
System Action: None.
User Response: None.
Message Type: INFO, REPLY.
KLVOP054 UNABLE TO INITIALIZE VTAM ACB: APPLID(applid)
Explanation: An attempt to allocate and initialize a VTAM ACB with the OPEN
command is unsuccessful.
System Action: The OPEN command fails.
User Response: Contact Candle Customer Support.
Message Type: ERROR.
KLVOP055 APPLICATION STOPPED: APPLID(applid)
Explanation: CT/Engine application applid terminates successfully.
System Action: None.
User Response: None.
Message Type: INFO.