Filter
Top Products
356 Candle Products Messages Manual (KLVHS–KONCT)
KN3CV136 VALID RANGE IS 10–3600
Explanation: The automatic screen refresh interval must be in the range of 10–
3600 seconds.
System Action: None.
User Response: Specify a number that is not less than 10 and is not greater
than 3600.
Message Type: User input error.
KN3CV137 THE CONTROL BLOCK CANNOT BE ACCESSED FOR ONE OF THE
FOLLOWING REASONS:
1. THE CONTROL BLOCK IS NO LONGER VALID.
2. AN ATTEMPT TO ACCESS THE ADDRESS SPACE FAILED
Explanation: The control block is not available for display because the control
block address is no longer valid, or an attempt to swap in the address space failed.
System Action: None.
User Response: Press Enter to continue.
Message Type: Information.
KN3CV138 THE ADDRESS SPACE HAS TERMINATED
Explanation: The control block data is not available for display because the
address space is gone.
System Action: None.
User Response: Press Enter to continue.
Message Type: Information.
KN3CV139 THE ADDRESS SPACE IS BEING SWAPPED IN, TRY AGAIN LATER
Explanation: The control block data is not available for display because the
address space is being swapped in.
System Action: None.
User Response: Press Enter to continue. Try to access the data at a later time,
after the address space has been swapped in.
Message Type: Information.
KN3CV140 THERE WAS NO RPL CONTROL BLOCK FOUND FOR THIS SESSION
Explanation: Due to the transient nature of control blocks, an RPL with a CID
matching this session's CID could not be found. The data cannot be displayed.
System Action: None.
User Response: Press Enter to continue.
Message Type: Information.
KN3CV141 UNABLE TO DISPLAY THE CONTROL BLOCK DATA. CHECK THE
MESSAGE LOG FOR MORE INFORMATION
Explanation: An error occurred while trying to display the requested data
System Action: None.
User Response: Press Enter to continue. Note the OMEGAMON II collector's
return and sense codes, on the message log or OMEGAMON II's SYSOUT, and
report them to Candle Support Services.
Message Type: Internal error.