Filter
Top Products
496 Candle Products Messages Manual (KLVHS–KONCT)
KONAF021 UNABLE TO OBTAIN LOCK — TYPE(lock_name) MODULE(error_module)
Explanation: While attempting to update monitor options for a user,
OMEGAMON II for VTAM determined that another user was also updating the
options.
System Action: OMEGAMON II for VTAM retries until successful or aborts the
request.
User Response: While this message sometimes occurs, persistent recurrence
warrants further investigation. If problem persists, gather the preceding 30
minutes of the RKLVLOG and any dumps that were produced or taken, and
contact Candle Support Services.
Message Type: Warning.
KONAF031 VTAM TABLE DISPLAY COLLECTOR FAILED — MODULE(error_module)
RC(return_code) SC(sense_code)
Explanation: The VTAM table display collector failed.
System Action: Processing continues.
User Response: Gather the preceding 30 minutes of the RKLVLOG and any
dumps that were produced or taken, and contact Candle Support Services.
Message Type: Internal error.
KONAF032 VTAM TABLE DISPLAY COLLECTOR FAILED DURING TERMINATION
PROCESSING — MODULE(error_module) RC(return_code)
SC(sense_code)
Explanation: The VTAM table display collector failed during termination of the
VTAM tables display function.
System Action: Processing continues.
User Response: Gather the preceding 30 minutes of the RKLVLOG and any
dumps that were produced or taken, and contact Candle Support Services.
Message Type: Internal error.
KONAF041 ETE CONNECTION FAILED — MODULE(error_module) RC(return_code)
SC(sense_code)
Explanation: During session establishment for a user, OMEGAMON II for VTAM
detected that the end-to-end response time environment was not connected.
OMEGAMON II for VTAM encountered an error while attempting to connect the
ETE environment.
System Action: Session establishment continues without the ETE feature.
User Response: Verify that the ETE started task is active and that you are
running the correct level of ETE. Also, review the information on enabling ETE in
the OMEGAMON II for VTAM Configuration and Customization Guide. Verify
that all steps completed are accurate. Then, retry logon. If problem persists, gather
the preceding 30 minutes of the RKLVLOG and any dumps that were produced or
taken, and contact Candle Support Services.
Message Type: Probable user error.