Filter
Top Products
148 Candle Products Messages Manual (KLVHS–KONCT)
KLVVT111 VTAM RPL REQUIRES n BYTES, ONLY m BYTES WERE RESERVED,
INCREASE &$ARBSP$
Explanation: The amount of storage reserved in the CT/Engine control block
$ARB is not sufficient for the amount used by the VTAM RPL generated.
System Action: After any subsequent startup modules are invoked, CT/Engine
terminates.
User Response: Retain the CT/Engine run sheets and dump files, this message,
and the MVS system log. Determine your system’s VTAM release level, then
contact Candle Customer Support.
Message Type: WARNING.
KLVVT112 VTAM INTERFACE INITIALIZED [,XA] [,AUTHORIZED PATH]
[,SPT=VTSPT]
Explanation: The VTAM interface has been initialized and XA and
AUTHORIZED PATH are displayed if used. VTSPT specifies the VTAM session
procedure timeout.
System Action: None.
User Response: None.
Message Type: INFO.
KLVVT113 KLVINVTM RKANPAR PARAMETERS:
Explanation: Module KLVINVTM logs its startup parameters as they are read
from RKANPAR. This is the header message and will be followed by message
KLVVT114.
System Action: None.
User Response: None.
Message Type: LOG.
KLVVT114 parameters
Explanation: As the parameters in module KLVINVTM are read, a log audit trail
is created.
System Action: None.
User Response: None.
Message Type: LOG.