Filter
Top Products
286 Candle Products Messages Manual (KLVHS–KONCT)
KMQMQ413I aaaaaaaa CCC for MQSeries stop accepted
Explanation: A successful request to terminate data collection for CICS
channels was entered. aaaaaaaa is the CICS applid.
System Action: Data collection for CICS channels will stop.
User Response: None.
KMQMQ414W aaaaaaaa MQSeries not active. Will retry connection
Explanation: An attempt was made to start data collection for CICS channel
monitoring support in CCC for MQSeries but the MQ manager for this CICS
region is not active. aaaaaaaa is the CICS applid.
System Action: The start request will be retried.
User Response: None.
KMQPD101E module ROUTINE FOR PDS function FAILED. POST CODE code
Explanation: Persistent Data Store routine failed for the specified module and
function. code is the post code from PDS routine.
System Action: If this message occurs several times, MQI tracing is disabled.
User Response: Check the RKPDLOG for Persistent Data Store error messages
and make sure that at least one of the datasets in the RKMQDSA group is
available for write access.
KMQRM104E ABEND RECOVERY ENTERED. CODE=ac FUNCTION=func
ADDRESS=Xaddress
Explanation: An abend has occurred within CCC for MQSeries where rc
indicates the abend code, func is the function that was in control, and Xaddress is
the address where the abend occurred.
System Action: Standard error recovery action is performed. A system dump
may be produced.
User Response: Note the message text and contact Candle Customer Support.
KMQTR101E BUFFER SIZE REQUESTED IS TOO LARGE
Explanation: An attempt was made to set the component trace table size to a
value outside the valid range. The BUFSIZE parameter, specified in an operator
TRACE CT command or in SYS1.PARMLIB(CTKMQ00), cannot exceed 2
megabytes.
System Action: The size of the internal trace table remains unchanged.
User Response: Specify a smaller trace buffer size through the use of TRACE
CT or the CTKMQ00 parmlib member.
KMQTR102E NO DEFINED TRACE COMPONENTS FOUND
Explanation: The component trace start/stop routine was invoked but no
component trace had been defined for the KMQ100 component.
System Action: None.
User Response: Contact Candle Customer Support for help in diagnosing the
problem.