Filter
Top Products
360 Candle Products Messages Manual (KLVHS–KONCT)
KN3CV160 STORAGE REQUIRED FOR MODELLING NOT AVAILABLE. ENSURE
THAT LIMIT(23,X) IS CODED FOR THE STARTUP PARAMETER.
Explanation: Storage required for SRT modeling is not available from the
existing storage pool. This storage requirement is temporary and equals 4 times
the new RACHSRT parameter in panel KN3DENM, plus 8. Typically, this
problem is due to the storage request exceeding the largest storage block allowed
for this job.
System Action: None.
User Response: Ensure that LIMIT(23,X) is coded for the start-up parameter in
member KN3SYSIN of the RKANPAR dataset. If the problem persists, you may
need to increase your MAXIMUM(,X) definition. Use command STORAGE D to
display and analyze your storage allocations.
Message Type: Probable user error.
KN3CV161 ENTER N, L, P, OR U
Explanation: The only acceptable characters to specify in this field are N
(NCPs), L (lines), P (PUs), and U (LUs).
System Action: None.
User Response: Enter a valid selection.
Message Type: User input error.
KN3CV162 ENTER M OR C
Explanation: The only acceptable characters to specify in this field are M
(monitor) and C (collect).
System Action: None.
User Response: Enter M or C in the field.
Message Type: User input error.
KN3CV163 ENTER S, M, H
Explanation: The only acceptable characters to specify in this field are S
(seconds), M (minutes), and H (hours).
System Action: None.
User Response: Enter an S, M, or H in the field.
Message Type: User input error.
KN3CV164 INVALID LINE TYPE; PRESS F4 FOR PROMPT.
Explanation: The input field accepts only the following line type defaults SDLC,
TRPL, TRLL, and NONE.
System Action: None.
User Response: Enter a valid line type, or press F4 for a prompt list.
Message Type: User input error.
KN3CV165 ENTER L, P, OR U
Explanation: The only acceptable characters to specify in this field are L (lines),
P (PUs), and U (LUs).
System Action: None.
User Response: Enter L, P, or U in the field.
Message Type: User input error.