Filter
Top Products
12 Candle Products Messages Manual (KLVHS–KONCT)
Message Type: INFO.
KLVIN000 CT/IX INTERFACE INITIALIZED
Explanation: The CT Posix environment has been successfully established.
System Action: None.
User Response: This message is informational.
KLVIN000 UNABLE TO REGISTER CT/iX THREAD or PROCESS ANCHOR: RC(9999)
Explanation: A fatal an unexpected error has occurred.
System Action: The process terminated.
User Response: Gather relavent logs and report this problem to Candle
Customer Support.
KLVIN001 INVALID CT/IX INTERFACE HEADER - <LMOD header>
Explanation: A fatal an unexpected error has occurred.
System Action: The process terminated.
User Response: Gather relavent logs and report this problem to Candle
Customer Support.
KLVIN400 TASK INITIALIZED: $DQA(dqa) TASK(task) $DSA(dsa) EVTBL(evtbl)
DPRTY(dprty)
Explanation: During CT/Engine start-up, the CT/Engine dispatcher started the
identified task to perform its work. The displayed fields contain information useful
for Candle diagnostic efforts.
System Action: None.
User Response: None.
Message Type: LOG.
KLVIN403 COMMAND LIBRARY UNAVAILABLE
Explanation: During CT/Engine start-up the command library, DD name
RKANCMD, could not be accessed. It is probably not present in the CT/Engine
JCL procedure.
System Action: Any data contained in the command library is unavailable.
User Response: Refer to the MVS system log for any IBM data management
messages (IEC). Determine the reason the command library could not be opened,
correct it, and restart CT/Engine.
Message Type: WARNING.
KLVIN405 STARTUP MODULE: modname [,@entry-point] SEQUENCE num [,USING
RKANPAR MEMBER member]
Explanation: During CT/Engine start-up, module modname with sequence
number num will be invoked. If an initialization parameter member of RKANPAR
is found for this module, it is identified as member in the message. The
entry-point address will only be included in the message if debug mode is in
effect.
System Action: None.
User Response: None.
Message Type: LOG.