Filter
Top Products
44 Candle Products Messages Manual (KLVHS–KONCT)
KLVOP142 INVALID MESSAGE TYPE: type
Explanation: An invalid message type type was specified as one of the
parameters of the MONITOR command.
System Action: The command fails.
User Response: Refer to the "CT/Engine Message Route Codes" appendix for
more information on message types.
Message Type: ERROR.
KLVOP143 INVALID PREFIX CHARACTER: prefix
Explanation: An invalid message type prefix prefix was specified as one of the
parameters of the CT/Engine MONITOR command.
System Action: The command fails.
User Response: Correct the invalid message type prefix (it must be (+) or (-))
and reissue the command.
Message Type: ERROR.
KLVOP152 MODULE NOT FOUND: module
Explanation: The entry name module specified in the LINK command could
not be found in the CT/Engine load library. This message is accompanied by
message KLVCM003, which indicates a more specific reason why the module
could not be found.
System Action: The command fails.
User Response: Determine if the entry name module is a valid member name
or alias in the CT/Engine load library.
Message Type: ERROR.
KLVOP161 CLOSE IN PROGRESS: APPLID(applid)
Explanation: The CLOSE command terminates application applid.
System Action: Termination is proceeding for the application.
User Response: None.
Message Type: REPLY.
KLVOP162 APPLICATION NOT OPEN: APPLID(applid)
Explanation: Application applid specified in the CT/Engine CLOSE command is
not open.
System Action: The command fails.
User Response: Re-enter the command with the correct applid.
Message Type: ERROR.
KLVOP164 CRITICAL APPLICATION CANNOT BE CLOSED:
APPLID(applid)
Explanation: Application applid specified in the CLOSE command is not
eligible to be terminated because it was opened with the critical attribute.
System Action: The CLOSE command fails.
User Response: Contact Candle Customer Support.
Message Type: ERROR.