Filter
Top Products
KOGCM001–KONCT303 501
KONAF060 VSAM LOGGING DISABLED — MODULE(error_module) REASON
(cccccccc)
Explanation: VSAM logging is disabled and the reason for it is cccccccc. This
message is usually accompanied by other messages in RKLVLOG. Following is the
list of possible reasons:.
System Action: VSAM logging is disabled.
User Response: Check for accompanying messages for any of the following
reasons:.
Message Type: Warning.
KONAF061 ERROR WHEN READING FROM DSN(dsname) — MODULE(error_module)
Explanation: An error occurred when reading from a VSAM cluster named
dsname. This indicates a DASD problem.
System Action: None.
User Response: Check for any accompanying messages in RKLVLOG and
respond according to those messages.
Message Type: Warning.
KONAF062 PUT FAILED FOR REASON OTHER THAN EOF FOR DSN(dsname) —
MODULE(error_module) FDBWD(fdbwd)
Explanation: OMEGAMON II for VTAM encountered an error while writing an
exception or interval record to the cluster dsname.
System Action: None.
User Response: Check for any accompanying messages in RKLVLOG and
respond according to those messages.
Message Type: Warning.
LOAD Some modules are missing.
ALLOC Error during VSAM dataset allocation.
INIT Error during initial load to VSAM cluster.
PUT Error during VSAM PUT. Probable DASD problem.
INTERNAL Internal error.
ABEND Abend occurred during logging to VSAM cluster.
VSAMSERV Internal VSAM services are unavailable.
LOAD Check installation.
ALLOC Check installation.
PUT, INIT Check for DASD problem.
INTERNAL,
ABEND
Contact Candle Support Services.
VSAMSERV Check to make sure that termination was requested. If it was not,
gather the preceding 30 minutes of the RKLVLOG and any dumps
that were produced or taken, and contact Candle Support
Services.