Filter
Top Products
KMQxx001E–KOCJ0046 243
KMQCI156E THE GROUP SPECIFIED IN THE EVENTQIN/OUT COMMAND DOES NOT
EXIST. THE GROUP MUST BE DEFINED BEFORE THIS COMMAND IS
ISSUED
Explanation: The syntax for the SET EVENTQIN or SET EVENTQOUT
command was correct, but the group name specified in the GROUP option has
not been defined to CCC for MQSeries.
System Action: The command is ignored.
User Response: Use the SET GROUP command to define the remote queue
manager; then resubmit the command. For instructions on using SET GROUP,
refer to the Candle Command Center User’s Guide for MQSeries.
KMQCI157I SET EVENTQIN/OUT COMMAND PROCESSED SUCCESSFULLY
Explanation: CCC for MQSeries accepted the SET EVENTQIN or SET
EVENTQOUT command.
System Action: The command is processed.
User Response: None. This is an informational message.
KMQCI158E THE MANAGER NAME SPECIFIED IN THE EVENTQIN/OUT COMMAND
HAS NOT BEEN DEFINED. IT MUST BE DEFINED BEFORE THIS
COMMAND IS ISSUED
Explanation: The syntax for the SET EVENTQIN or SET EVENTQOUT
command was correct, but the manager name specified in the MGRNAME option
has not been defined to CCC for MQSeries.
System Action: The command is ignored.
User Response: Use the SET MANAGER command to define the remote
queue manager; then resubmit the command. For instructions on using SET
MANAGER, refer to the Candle Command Center User’s Guide for MQSeries.
KMQCI301I GROUP(group_name) IS ESTABLISHED WITH FOLLOWING
SPECIFICATIONS: DEFAULT(YES|NO) EVENTS(REMOVE|BROWSE|NO)
REMOTEQ(remote_queue_name) AGGRHIST(aggregation_samples)
RETAINHIST(historical_aggregation_value)
Explanation: This message is issued in response to the DISPLAY SETTINGS
command and displays information from the previously issued SET GROUP
command(s).
System Action: None.
User Response: None. This is an informational message only.
KMQCI302I MANAGER SET(manager_name_mask) IS ESTABLISHED WITH
FOLLOWING SPECIFICATIONS: GROUP(group_name)
SYSNAME(MVS_system_id) EVENTS(REMOVE|BROWSE|NO)
ACTIVE(YES|NO) AGGRHIST(aggregation_samples)
RETAINHIST(historical_aggregation_value)
Explanation: This message is issued in response to the DISPLAY SETTINGS
command and displays information from the previously issued SET MANAGER
command(s).
System Action: None.
User Response: None. This is an informational message only.