Filter
Top Products
146 Candle Products Messages Manual (KLVHS–KONCT)
KLVVT101 VTAM EXLST GENERATION ERROR: R15(r15) R0(r0) TERMINATION
SCHEDULED
Explanation: An error was detected during the generation of a VTAM EXLST.
System Action: After any subsequent startup modules are invoked, CT/Engine
terminates.
User Response: Consult the IBM manual ACF/VTAM Programming to
determine the cause of the error. Correct it, and restart CT/Engine. The return
code appears in the r15 field and the error return code appears in the r0 field.
Message Type: ALERT.
KLVVT102 VTAM ACB GENERATION ERROR: R15(r15) R0(r0) TERMINATION
SCHEDULED
Explanation: An error was detected during the generation of a VTAM ACB
GENCB macro.
System Action: After any subsequent startup modules are invoked, CT/Engine
terminates.
User Response: Consult the IBM manual ACF/VTAM Programming to
determine the cause of the error. Correct it, and restart CT/Engine. The return
code appears in the r15 field and the error return code appears in the r0 field.
Message Type: ALERT.
KLVVT103 EXCESS BYTES RESERVED IN $ACB FOR VTAM ACB: NEEDED(nbytes)
ALLOCATED(mbytes) EXCESS(mbytes-nbytes)
Explanation: The length of the VTAM ACB generated is less than the amount of
storage reserved for the ACB in the CT/Engine control block $ACB.
System Action: None.
User Response: None.
Message Type: LOG.
KLVVT104 VTAM NIB GENERATION ERROR: R15(r15) R0(r0) TERMINATION
SCHEDULED
Explanation: An error was detected during the generation of a VTAM NIB
(GENCB macro).
System Action: After any subsequent startup modules are invoked, CT/Engine
terminates.
User Response: Consult the IBM manual ACF/VTAM Programming to
determine the cause of the error. Correct it, and restart CT/Engine. The return
code appears in the r15 field and the error return code appears in the r0 field.
Message Type: ALERT.
KLVVT105 EXCESS BYTES RESERVED IN $NIB FOR VTAM NIB: NEEDED(nbytes)
ALLOCATED(mbytes) EXCESS(mbytes-nbytes)
Explanation: The length of the VTAM NIB generated is less than the amount of
storage reserved for the RPL in the CT/Engine control block $CRB.
System Action: None.
User Response: None.
Message Type: LOG.