Filter
Top Products
320 Candle Products Messages Manual (KLVHS–KONCT)
KN3AF134 NCP TOPOLOGY NOT CREATED. WILL RETRY NEXT ACT CYCLE
INTERVAL
Explanation: The NCP resources have not been received from the NCP
collector task.
System Action: None
User Response: After a reasonable amount of time, if the NCP performance
status light continues to display N/A, check the NPALU connection to
OMEGAMON II for VTAM.
Message Type: Warning
KN3AF135 ACT LOCATE FAILED RC(return_code) SC(sense_code)
MODULE(module_name)
Explanation: An error was encountered in locating the automatic collection task
(ACT) work area. The ACT return code, sense code, and issuing module are
displayed in the message text.
System Action: OMEGAMON II for VTAM cannot successfully complete
initialization.
User Response: Log the diagnostic information and contact Candle Support
Services.
Message Type: Internal error.
KN3AF136 KN3AXNPB ADD_NPB FUNCTION FAILED RC(return_code)
MODULE(module_name)
Explanation: An error occurred while adding an NCP parameter block (NPB) to
the NPB chain. Return code and issuing module are displayed in the message
text.
System Action: If the error occurred in module KN3AFNMI, the NCP
component cannot successfully complete initialization. However, if the error
occurred in a module other than KN3AFNMI, only the ADD for the selected
resource fails.
User Response: Log the diagnostic information and contact Candle Support
Services.
Message Type: Internal error.
KN3AF137 KN3AXNSB ADD FUNCTION FAILED RC(return_code)
MODULE(module_name)
Explanation: An error occurred while adding an NCP parameter block (NPB) to
the NPB chain. Return code and issuing module are displayed in the message
text.
System Action: If the error occurred in module KN3AFNMI, the NCP
component cannot successfully complete initialization. However, if the error
occurred in a module other than KN3AFNMI, only the ADD for the selected
resource fails.
User Response: Log the diagnostic information and contact Candle Support
Services.
Message Type: Internal error.