Filter
Top Products
KMQxx001E–KOCJ0046 403
KN3ND034 KEYWORD(keyword) ON(macro_name) MACRO WITH LABEL(label_name)
IS NOT SPECIFIED
Explanation: This keyword is not explicitly specified on the macro with the
indicated label in the NCP source member. The keyword is used by the NCP
statistics component.
System Action: Some calculated statistics may not be available. See the
Planning chapter in the OMEGAMON II for VTAM Configuration and
Customization Guide.
User Response: Specify the keyword on the macro in the NCP source
member.
Message Type: Warning.
KN3ND035 DYNAMIC MOVE FAILED TO FIND (resource_name) RESOURCE IN
CURRENT TOPOLOGY
Explanation: A target or source resource, resource_name, was not found in the
current topology during a dynamic move. NCP topology information may be
incorrect.
System Action: None.
User Response: Log the information for problem diagnosis, and contact
Candle Support Services.
Message Type: Internal error.
KN3ND036 RRT RELEASE LEVEL rrt_level UNKNOWN FOR NCP_name. USING
LEVEL rrt_level1 NCP RELEASE ncp-level.
Explanation: The NCP(NCP_name) is not generated at a supported release
level and cannot be monitored at that level.
System Action: The NCP will be monitored using rrt_level1 and ncp-level as
shown in the message.
User Response: If the NCP is a supported release, contact Candle Support
Services.
Message Type: Internal error.
KN3ND037 NCP WILL NOT BE MONITORED
Explanation: The NCP(NCP_name) specified in previous messages cannot be
monitored.
System Action: None.
User Response: See previous messages.
Message Type: Information.
KN3ND100 NCP DATA MANAGER TASK AVAILABLE FOR REQUESTS
Explanation: The NCP data manager task can receive requests.
System Action: None.
User Response: None.
Message Type: Confirmation.