Filter
Top Products
3. General
a) Measure and install the two supplied mounting brackets on your rear rack rails.
Image 3-2
b) Measure the distance between the front and rear rack rails. Remove the four mounting screws that secu
re each side rail to
the E2, and then adjust the spacing of each side rail as necessary.
Image 3-3
1 Chassis rear
2Siderail
3 Mounting screws
c) Re-install the mounting screws. When properly adjusted, the end of each side rail w ill protrude through the slot in the rear
mounting bracket, once the chassis is rack mounted.
Image 3-4
To take advantage of this feature, ensure that there is at least 1/2” of c learance above the chassis.
Image 3-5
2. For the E2’s two keyhole slots, measure and install two rack screws in your equipment rack’s front rails. A llow each screw to
protrude approximately 3/4” from the surface of the rails.
3. Lift the chassis, and while supporting it, slide the side r ails through the slots in the rear m ounting brackets.
26
R5905948 E2 12/12/2014