Filter
Top Products
7. System Setup
7.6 Restoring the system
This step in the E2 setup procedure is optional. If there is not backup available or if you decid e to configure
your u nit from scratch, please m ove to the n ext step to continue the procedure.
General
In this procedure, you will restore your system configuration from a USB drive — pr ovided that you prev iously backed up your system
to a USB drive.
Prerequisite
• Ensure that you ar e familiar with the USB device (Backup/Restore) M enu. F or details on this menu, please refer to c hapter
"System menu > USB device (B ackup/Restore)", page 54.
Restore a system configuration file
Use the following steps to restore your system from the USB Drive:
1. Insert a formatted flash drive in the E2’s front-panel USB port.
2. From the System menu, scroll to the USB Backup/Restore subm enu. Select Restore Config.
The USB Restore Config submenu appears.
3. Press SE L and scroll through the list of configuration files. When you locate the file you w ant, p ress SEL again.
A message confirms the restore operation and instructs you to reboot the E2.
You must reboot the E2 to use the restored configu r a tion file.
At the conclusion of this procedure, your system is completely set up — exactly the way that you left it when
you pe rformed a complete system “backu p.” No further setup operations are required.
R5905948 E2 12/12/2014 163