Filter
Top Products
10. Maintenance
10.28 Genlock Cable
Image 10-72
The flat ribbon G enlock cable connects the Genlock Assembly to the System-Power board. This procedure
provides instructions on how to disconnect the c able on both sides.
Make su re the latches are fully engag ed to prevent the cable from co ming loose.
Concerned parts
R767269K
Cable Kit S et
Necessary tools
• 1 x Phillips Screwdriver #2
• Hex Sc re w driver
How to remove the Genlock cable
1. Remove the Genlock Assembly and disconnect the Genloc k cable f rom the board. Follow the instructions as provided in the
previous section.
2. Turn the unit upside down and follow the steps detailed in other procedures to remo ve the Bottom Panel and the CPU m odule
from the System-Power board.
3. Remove the USB , VFD, 3RU and 1RU cables that are connected to the S ystem-Power board.
4. Remove the screws that attach the System-Power Board to the standoffs.
5. Lift the System Power Board from the standoffs and flip it over, but don’t exte
nd it too m uch.
6. Unplug the side of the Genlock c able that is plugged into the System P ower board.
262
R5905948 E2 12/12/2014