Filter
Top Products
B. Remote Control Protocol
B.2 E2RemoteCommands
General
This section lists the E 2 remote commands, s orted by name.
ATRN
• Description: Performs an A uto Transition on the currently ac tive destinations. The currently selected Effect type, rate and edge
width will be used to transition pr eview to program.
• Command Format: ATRN <transTime>
• Parameters:
<transTime> (optional)
Used to spec ify a transition time (duration of the transition) in frames. Value ranges from 0 to 1999. A 0 specify a cut transition.
Any non-zero value (within range) will override the transition time in the controller. If this argument is not specified, the current
transition time known by the controller will b e used.
• Examples:
> ATRN 200
(Transition Preview to Program on currently active de stinations in 200 frames )
> ATRN 0
(Transition P review to Program immediately. This is a CUT.)
> ATRN
(Transition Preview to Program using the transition time set in the controller)
• Query Format: N/A
• Query Response: N/A
PRESET
• Description: Preset Settings.
• Command Format: PRESET
• Parameters:
-s (save preset, 1-1000)
-r (recall pr eset, 1-1000)
• Examples:
> PRESET -s 1
(Save currently selected destinations to preset 1)
> PRESET -r 10
(Recall preset 10)
• Query Format: N/A
• Query Response: N/A
R5905948 E2 12/12/2014
293