Filter
Top Products
B. Remote Control Protocol
B.1 E2 Remote control Introduction
General
The user can remotely control the E2 via a telnet connection to the unit’s IP address.
How accessing the E2 remotely
To access the E2 remote commands, use the following procedure:
1. In a command prompt window, type a telnet command in the following format:
> telnet nnn.nnn.nnn.nnn 9878
where the n’s rep resent the E2 IP address and 9878 is the port.
2. Press Enter
The command prompt appears.
3. At the comm and prompt, type a specific E2 remote control command and press Enter.
292
R5905948 E2 12/12/2014