Filter
Top Products
204
Manually Creating Embroidery Patterns From Images (Design Center)
Rotating numerically:
1. Select the outline that you want to rotate.
2. Click Edit, then Numerical Setting, then
Rotate.
→ The Rotate dialog box appears.
3. Type or select the desired rotation angle.
4. Click OK.
■ Deleting outlines
1. Select the outline to be deleted.
2. Press the key, or click Edit, then
Delete.
■ Cutting out outlines
1. Select one or more outlines.
2. Click , or click Edit, then Cut.
→ The selected outlines are removed from
the work area.
■ Copying outlines
1. Select one or more outlines.
2. Click , or click Edit, then Copy.
→ The selected outlines are copied onto the
Clipboard and are ready to be pasted.
■ Pasting a cut or copied outline
1. Click , or click Edit, then Paste.
→ The outlines saved on the Clipboard
(using the Cut or Copy command) are
pasted into the work area.
■ Undoing an operation
1. Click , or click Edit, then Undo.
→ The previous operation is canceled, and
the pattern reverts to its condition before
the operation was performed. (You can up
to 20 Undos in Design Center.)
■ Reverting an undone operation
1. Click , or click Edit, then Redo.
→ The previously canceled operation is
canceled, and the pattern reverts to its
condition before the operation was
canceled. (You can up to 20 Redos in
Design Center.)
b Memo:
To rotate the outline in 15° increments, hold
down the key while dragging the
rotation handle.
b Memo:
• The angle can also be specified by moving
the pointer over the red arrow inside of the
circle, then dragging the red arrow to the
desired angle. When the pointer is moved
over the red arrow, its shape changes to
.
• Select
0 degree
to leave the outline
unchanged.
b Memo:
• To preview the outline at the new angle in
the Design Page, click
Preview
.
• To close the dialog box without applying the
changes to the settings, click
Cancel
.
a Note:
The range of values that can be entered is
between 0 and 359 degrees, in 1-degree
increments.
Shift
Delete
b Memo:
Since the removed outlines are saved on the
Clipboard, you can paste them back using the
menu command
Edit
–
Paste
.