Filter
Top Products
117
Arranging Embroidery Designs (Layout & Editing)
→ The dotted line that is drawn when you
move the pointer changes to a solid line
when the next point is specified.
5. Double-click in the Design Page to specify the
section to be split off.
6. Edit the cutoff section as desired.
b Memo:
• To remove the last point that was entered,
click the right mouse button. Each
successive right-click removes points, one
by one, in the opposite order that they were
entered. Once all points are deleted, the
Tool Box buttons are available again,
however, the application remains in Split
stitch mode.
• An enclosure is valid only if it contains stitch
data. If it contains no stitch data, an error
message appears, and the enclosure is
erased, but the application remains in Split
stitch mode.
• Sections enclosed several times by lines of
an intricate figure alternate between being
selected and deselected. Therefore, in a
figure like a pentagram for instance, only
the points are selected, and the center is
deselected as it has been enclosed twice.
a Note:
• Only one cutoff section can be specified
from the pattern at one time. Repeat the
procedure for each piece of the pattern
that you want to cut off.
• The cutoff piece moves to the end of the
sewing order and the thread color order
appears in the order selected for the
original pattern.