Filter
Top Products
Reference Manual
300530EN, Rev BA
September 2012
Rosemount 2410
6-12
Section 6. Service and Troubleshooting
6.2.10 Simulation Mode The Simulation Mode function lets you verify communication between a
Rosemount 2410 Tank Hub and a host system without connecting actual field
devices. The 2410 Tank Hub Simulation window allows you to choose which
parameters to be calculated by the 2410. The calculations are based on input
from simulated tank measurement data such as product level, average
temperature, liquid pressure, and other variables.
The Simulation HREGS holding registers (starting with register number
3800) lets you specify the desired simulation data.
For information on how to view and edit holding registers, see “Viewing Input
and Holding Registers” on page 6-2 or the Raptor System Configuration
Manual (Document No. 300510EN).
1. In the TankMaster WinSetup workspace select the 2410 icon.
2. Click the right mouse button and choose the Simulation option to open
the 2410 Tank Hub Simulation window:
Figure 6-3. Simulation window in
TankMaster WinSetup
3. Choose simulation mode Single Tank and the desired tank in the Tank
Position field, or choose the All option to simulate all tanks connected to
the 2410. Tank Position refers to the position in the 2410 tank database.
4. In the Simulation Time field, enter for how long the simulation will
continue.
Simulation can be stopped at any time by pressing the Stop button.
5. Calculate Parameter:
in the standard configuration the check-boxes are unchecked, which
means that each simulation parameter is given a specific standard
simulation value as specified in the simulation holding register area:
6. Click the Start button to start simulating the tank parameters.
7. In the WinSetup workspace the 2410 icon changes to the following
appearance to indicate that Simulation Mode is active:
Simulation Parameter Simulation Holding Register
Average Temperature HR3868
Total Observed Volume HR3994
Observed Density HR3976