Filter
Top Products
Reference Manual
300530EN, Rev BA
September 2012
Rosemount 2410
5-8
Section 5. Operation
5.6 SPECIFYING
DISPLAY
VARIABLES
The Rosemount 2410 can be configured to present measurement data on the
optional integral display. Measurement data such as Level, Level Rate, Free
Water Level and many other tank variables can be displayed.
Measurement units for Level, Volume, Temperature, Density, Pressure, and
Weight can be specified.
The display will alternate between the selected items at a rate given by the
Display Toggle Time parameter.
The display can easily be set up when the 2410 is installed and configured
with the TankMaster WinSetup program, and the current display settings can
be changed at any time in the 2410 Properties window as shown in Figure 5-6
below:
1. In the TankMaster WinSetup configuration program click the right mouse
button on the Rosemount 2410 icon.
2. Choose the Properties option.
3. In the 2410 Tank Hub window select the Local Display tab.
Figure 5-6. The local display can
be configured to show tanks and
measurement variables by using
the Rosemount TankMaster
Winsetup configuration software
4. Select the desired tanks and tank parameters.
5. Choose measurement units for the 2410 integral display. The first time
the Local Display tab is opened, the same measurement units are used
as specified in the TankMaster WinSetup Server Preferences/Units
window.
6. Click the OK button to save the configuration and close the window.
See the Raptor System Configuration Manual (Document no. 300510EN) for
more information on using the TankMaster Winsetup PC software to configure
the Rosemount 2410.