Filter
Top Products
Reference Manual
300530EN, Rev BA
September 2012
Rosemount 2410
5-2
Section 5. Operation
5.2 INTEGRAL
DISPLAY
The Rosemount 2410 Tank Hub can be equipped with an optional integral
display for presentation of measurement data and diagnostics. When the
device is switched on, the display presents information such as device model,
communication protocol (Modbus, Enraf, etc.) and adress, relay configuration,
software version, serial number, unit ID, and write protection status. See Table
5-2 on page 5-4 for more information on start-up information.
When the 2410 is up and running the display presents Level, Signal
Amplitude, Volume and other measurement variables depending on how the
display is configured. The available parameters are listed in Table 5-1 on
page 5-3.
The display has two rows for data presentation. The upper row shows tank
name (up to six characters) and measurement values. The lower row shows
variable type and measurement unit.
You can specify which variables to present on the display by using a
configuration tool such as the Rosemount TankMaster WinSetup program,
see “Specifying Display Variables” on page 5-8 for more information.
The display toggles between different measurement values and units at a rate
which can be configured by using the WinSetup program.
Figure 5-1. The Rosemount
2410 integral display
Measurement value
Toggling between measurement
variable and
measurement unit
Write protection switch