Filter
Top Products
Reference Manual
300530EN, Rev BA
September 2012
Rosemount 2410
www.rosemount-tg.com
Section 5 Operation
5.1 Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5-1
5.2 Integral Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5-2
5.4 Error Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5-5
5.5 LED . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5-6
5.6 Specifying Display Variables . . . . . . . . . . . . . . . . . . page 5-8
5.1 SAFETY
MESSAGES
Procedures and instructions in this section may require special precautions to
ensure the safety of the personnel performing the operations. Information that
raises potential safety issues is indicated by a warning symbol ( ). Please
refer to the following safety messages before performing an operation
preceded by this symbol.
Failure to follow safe installation and servicing guidelines could result in death or
serious injury:
Make sure only qualified personnel perform the installation.
Use the equipment only as specified in this manual. Failure to do so may impair the
protection provided by the equipment.
Do not perform any service other than those contained in this manual unless you are
qualified.
Explosions could result in death or serious injury:
Verify that the operating environment of the device is consistent with the appropriate
hazardous locations certifications.
Before connecting a communicator in an explosive atmosphere, make sure the
instruments in the loop are installed in accordance with intrinsically safe or
non-incendive field wiring practices.
Do not remove the gauge cover in explosive atmospheres when the circuit is alive.