Filter
Top Products
Reference Manual
300530EN, Rev BA
September 2012
Rosemount 2410
5-4
Section 5. Operation
5.3 START-UP
INFORMATION
When the Rosemount 2410 starts up, all LCD segments light up for
approximately 5 seconds. The start-up information appears on the display
when the software initialization procedure is finished. The Primary Bus
configuration appears first, followed by the Secondary Bus configuration.
Each item appears a few seconds on the display:
Table 5-2. Start-up information
on the 2410 display
Item Example
Model number and type (multiple / single tank version) 2410 MULTI
Primary communication bus hardware option (TRL2, RS485, Enraf GPU,
HART master, HART slave)
PR HW
RS-485
HART M
HART S
SIL AR
Primary communication bus protocol PRI
MODBUS
Primary Bus communication address ADDR
247
Primary Bus communication settings (Baud rate, stop bits and parity) 9600
2 0
Secondary communication bus hardware option (TRL2, RS485, Enraf GPU,
HART wireless, HART master, HART slave)
EN GPU
HART W
HART M
HART S
SIL AR
Secondary communication bus protocol SEC
ENRAF
Secondary Bus communication address
Secondary Bus commuincation settings (Baud rate, stop bits and parity)
Software version 1.B1
SW
Serial number SN 12
345678
Unit ID (when Modbus is available on Primary or Secondary bus) UNID
23456
Write protection status (ON/OFF) ON
W PROT
Relay option --K2
RELAY