Filter
Top Products
Reference Manual
300530EN, Rev BA
September 2012
1-5
Rosemount 2410
Section 1. Introduction
1.5 SERVICE SUPPORT For service support contact the nearest Emerson Process
Management/Rosemount Tank Gauging representative. Contact information
can be found on the web site www.rosemount-tg.com.
1.6 PRODUCT RECYCLING/DISPOSAL
Recycling of equipment and packaging should be taken into consideration
and disposed of in accordance with local and national legislation/regulations.
The label below is put on Rosemount Tank Gauging products as a
recommendation to customers if scrapping is considered.
Recycling or disposal should be done following instructions for correct
separation of materials when breaking up the units.
Figure 1-1. A green label is
placed on the housing of the
2410 Tank Hub
1.7 PACKING
MATERIAL
Rosemount Tank Radar AB is fully certified according to ISO 14001
environmental standards. By recycling the corrugated paperboard, or wooden
boxes, used for shipping our products you can contribute to take care of the
environment.
1.7.1 Reuse and
Recycling
Experience has shown that wooden boxes can be used several times for
various purposes. After careful disassembly the wooden parts may be reused.
Metal waste may be converted.
1.7.2 Energy recovery Products which have served their time may be divided into wood and metal
components and the wood can be used as fuel in sufficient ovens.
Due to its low moisture content (approximately 7%) this fuel has a higher
calorific value than ordinary wood fuel (moisture content approximately 20%).
When burning interior plywood the nitrogen in the adhesives may increase
emissions of nitrogen oxides to the air 3-4 times more than when burning bark
and splinter.
NOTE!
Landfill is not a recycling option and should be avoided.
S
E
P
A
R
A
T
E
S
T
E
E
L
&
P
L
A
S
T
I
C