Polycom DOC2091A Water System User Manual


 
6Chapter 1 Getting StartedGlobal Management System User’s Guide
Endpoint setup
V-Series
Make sure the unit is connected to the LAN and is turned on. V-Series will auto detect LAN prop-
erties and provide guidance in setting up this feature.
ViewStation Support
For Global Management System to fully support management and monitoring of the ViewStation,
You will need to:
Connect ViewStations to the LAN
Install Global Management System software on a computer that meets the minimum
system requirements
Update the ViewStations software to at least version 6.0
You must update ViewStations software to at least Version 6.0, otherwise, Global Management
System cannot provide the system status information for ViewStations that are not yet updated.
For instructions on connecting your ViewStations to your LAN please refer to page 114.
ViaVideo Support
Install the latest ViaVideo software version. Updating the ViaVideo software cannot be done
through Global Management System Software Update feature. This must be done manually from
each PC unit.
Make sure the PC is connected to the LAN.
For iPower Support:
Install the latest iPower software version. Updating the iPower software cannot be done through
the Global Management System Software Update feature. This must be done manually for each
iPower unit. Please refer to page 115 for instructions on enabling Global Management System
support on iPower.
For SoundStation VTX 1000 Support:
Upgrade SoundStation VTX 1000 Software to release 1.30 or later.
Before You Begin
NOTE
If a SoundStation VTX 1000 has code that is down-rev to version 1.30 (1.29 or earlier), the
phone must be manually updated to version 1.30 through the SoundStation VTX 1000 user
interface (see Administrator’s Guide) before the Global Management System can provide
remote software support.