Filter
Top Products
11
Table 9 — Outputs Mode and Sub-Mode Directory (cont)
NOTE: If the unit has a single circuit, the Circuit B items will not appear in the display, except the ability to configure circuit B will be displayed.
Table 10 — Configuration Mode and Sub-Mode Directory
NOTE: If the unit has a single circuit, the Circuit B items will not appear in the display, except the ability to configure circuit B will be displayed.
SUB-MODE
KEYPAD
ENTRY
ITEM DISPLAY
ITEM
EXPANSION
COMMENT
A.EXV OUTPUTS CIRCUIT A EXV
EXV.A 0 to 100% EXV % OPEN
APPR ON/OFF CIRCUIT A APPROACH
AP.SP APPROACH SETPOINT
X.SH.R SH RESET AT MAX UNL-DIG
S.SH.R DIGLOAD TO START SH RST
SH_R AMOUNT OF SH RESET
OVR.A EXVA OVERRIDE
SPH.A SUCTION SUPERHEAT TEMP
ASH.S ACTIVE SUPERHEAT SETPT
AMP.S ACTIVE MOP SETPT
PLM.A CIR A EXV POSITION LIMIT
SPR.1 SPARE 1 TEMPERATURE
B.EXV OUTPUTS CIRCUIT B EXV
EXV.B 0 to 100% EXV % OPEN
APPR ON/OFF CIRCUIT B APPROACH
AP.SP APPROACH SETPOINT
OVR.B EXVB OVERRIDE
SPH.B SUCTION SUPERHEAT TEMP
ASH.S ACTIVE SUPERHEAT SETPT
AMP.S ACTIVE MOP SETPT
PLM.B CIR B EXV POSITION LIMIT
SPR.2 SPARE 2 TEMPERATURE
CIR.A OUTPUTS CIRCUIT A
CC.A1 ON/OFF COMPRESSOR A1 RELAY
DPE.R ON/OFF COMP A1 LOAD PERCENT
CC.A2 ON/OFF COMPRESSOR A2 RELAY
CC.A3 ON/OFF COMPRESSOR A3 RELAY
CC.A4 ON/OFF COMPRESSOR A4 RELAY
CIR.B OUTPUTS CIRCUIT B (See Note)
CC.B1 ON/OFF COMPRESSOR B1 RELAY
CC.B2 ON/OFF COMPRESSOR B2 RELAY
CC.B3 ON/OFF COMPRESSOR B3 RELAY
CC.B4 ON/OFF COMPRESSOR B4 RELAY
SUB-MODE
KEYPAD
ENTRY
ITEM DISPLAY
ITEM
EXPANSION
COMMENT
DISP DISPLAY CONFIGURATION
TEST ON/OFF TEST DISPLAY LEDS
METR ON/OFF METRIC DISPLAY Off = English; On = Metric
LANG X LANGUAGE SELECTION
Default: 0
0 = English
1 = Espanol
2 = Francais
3 = Portuguese
PAS.E ENBL/DSBL PASSWORD ENABLE Default: Enable
PASS xxxx SERVICE PASSWORD Default: 1111
ENTER
ENTER
ENTER
ENTER
ENTER