Filter
Top Products
Programming
100 MS-9200UDLS PN 52750:E1 01/27/09
3.6.5.3 Time-Date
The control panel time and date can be changed by pressing 3 while viewing the
System Setup Screen #1. The following screen will be displayed:
3.6.5.3.1 Time
To change the time, press 1 while viewing the Time-Date Screen. The following
screen will be displayed:
A flashing cursor is located toward the top left of the display. Below the cursor is
the current time. To change the time, enter the two-digit hours followed by the two-
digit minutes. The cursor will move one position to the right each time a digit is
entered. After the last minutes digit is entered, the cursor will again move one
position to the right. At this point enter 1 for AM or 2 for PM. The display will
then return to the Time-Date Screen which will show the new time entry. If an error
is made while entering a digit, press the CLR key to delete the entire entry and
beginning again.
SYSTEM SETUP
1=TROUBLE REM
2=BANNER
3=TIME-DATE
System Setup Screen #1
TIME AND DATE
1=TIME 10:00 AM
2=DATE 04-07-2006
3=CLOCK FORMAT 12HR
Time-Date Screen #1
TIME AND DATE
1=DAYLIGHT SAVINGS
Time-Date Screen #2
ENTER TIME
10:00 AM
1=AM 2=PM
Time Screen