boot
OVERVIEW
Switch ManagementCategory:
managerPrimary context:
reload (page 467)Related Commands
Usage: boot [system [ash <primary|secondary>] [cong FILENAME]]
boot set-default ash <primary|secondary>
boot active
boot standby
Description: Reboot the device. The primary or secondary software image
can be specied to be used during the boot process.
Optionally, a conguration le can be set for this boot.
Parameters:
o set-default- Sets the default ash boot image for next boot.
o active - Causes switchover and reboots the active management
module, if redundancy is enabled and the other module
is present. Reboots the system if redundancy is disabled
or the module is not present.
o standby - Reboots the standby management module.
NOTES
Italicized "config" Keywords
The italicized "config | config1" keywords correspond to the names selected for the config
files.
COMMAND STRUCTURE
■ boot active -- Reboot the active management module. (p. 73)
■ boot set-default -- Specify the default flash boot image. (p. 74)
■ flash < primary | secondary > -- Specify the default flash boot image. (p. 74)
■ boot standby -- Reboot the standby management module. (p. 74)
■ boot system -- Allows user to specify boot image to use after reboot. (p. 75)
■ flash < primary | secondary > -- Specify boot image to use after reboot. (p. 74)
■ config < config | config1 > -- Specify configuration file to use on boot. (p. 74)
COMMAND DETAILS
standby (p. 74)flash (p. 74)active (p. 73)
system (p. 75)set-default (p. 74)config (p. 74)
active
■ boot active
Note: This command applies to the 8212zl switch only.
Reboot the active management module. The switch starts to boot from the
default ash image. You can select which image to boot from during the
boot process itself. The switch will switchover to the standby management
73© 2009 Hewlett-Packard Development Company, L.P.
