poison-reverse
■ [no] vlan VLAN-ID ip rip poison-reverse
Enable/disable poison reverse on this interface.
■ [no] vlan VLAN-ID ip rip IP-ADDR poison-reverse
Enable/disable poison reverse on this interface.
■ [no] vlan VLAN-ID ip rip all poison-reverse
Enable/disable poison reverse on this interface.
port-name
■ [no] vlan VLAN-ID ip forward-protocol udp IP-ADDR < dns | ntp | netbios-ns | ... >
Supported Values:
■ dns -- Domain Name Service (53)
■ ntp -- Network Time Protocol (123)
■ netbios-ns -- NetBIOS Name Service (137)
■ netbios-dgm -- NetBIOS Datagram Service (138)
■ radius -- Remote Authentication Dial-In User Service (1812)
■ radius-old -- Remote Authentication Dial-In User Service (1645)
■ rip -- Routing Information Protocol (520)
■ snmp -- Simple Network Management Protocol (161)
■ snmp-trap -- Simple Network Management Protocol (162)
■ tftp -- Trivial File Transfer Protocol (69)
■ timep -- Time Protocol (37)
port-num
■ [no] vlan VLAN-ID ip forward-protocol udp IP-ADDR TCP/UDP-PORT
UDP port number of the server.
preempt-delay-time
■ [no] vlan VLAN-ID vrrp vrid < 1 to 255 > preempt-delay-time < 1 to 600 >
Usage: [no] vrrp vrid <VRID> preempt-delay-time <1-600>
Description: Allows you to specify a time in seconds that the Owner router
will wait before taking control of the virtual IP address and
beginning to route packets. You can congure the time on VRRP
Owner and Backup routers.
The "no" form of the command may be used to disable the
pre-emptive delay timer.
Note: If you have congured the Preempt Delay Timer with a non-zero
value, you must use the "no" form of the command to change it
to zero.
Parameters:
o preempt-delay-time <1-600> - The number of seconds to delay.
741© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide
