Next Available Option:
■ port-name -- Specify a port name up to 64 characters length. (ASCII-STR) (p. 263)
■ interface vlan VLAN-ID name NAME
Usage: name ASCII-STR
Description: Set the VLAN's name.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
■ interface svlan VLAN-ID name NAME
Usage: name ASCII-STR
Description: Set the VLAN's name.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
nbr-timeout
■ interface vlan VLAN-ID ip pim-sparse nbr-timeout < 60 to 8000 >
Usage: ip pim-sparse nbr-timeout <60-8000>
Description: Set the neighbour loss time interval for this interface.
Default is 180 seconds.
Range: < 60 to 8000 >
nd
■ [no] interface vlan VLAN-ID ipv6 nd
Usage: [no] ipv6 nd <parameter>
Description: IPv6 nodes on the same link use Neighbor Discovery to
discover each other's presence, link-layer addresses,
routers and to maintain reachability information about the
paths to active neighbors.
<parameter> - Congure various Neighbors Discovery parameters.
o ns-interval
o reachable-time
Next Available Options:
■ ns-interval -- Configures the neighbor discovery time between neighbor solicitation requests
sent for an unresolved destination, or between duplicate address detection neighbor solicitation
requests(p. 256)
■ reachable-time -- Configures the length of time neighbors are considered reachable after being
confirmed as reachable via the neighbor unreachability detection algorithm(p. 273)
no-default
■ interface vlan VLAN-ID ip irdp preference no-default
255© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide
